Page
24VF Gas Fireplace
Part No. XG0138
Horizon
Removing and Installing
the Door
Take care when removing the screen door, and ensure that the fire
-
place has been properly cooled before handling the screen door.
Do not attempt to remove the door when hot.
Removing the Door:
Remove the screen door by lifting it up by the two door tabs on the
bottom of the door. Swing out the bottom of the door si it clears the
bottom door rail, as illustrated in figure 8a.
Installation
Figure 8a.
Removing the sceen door.
Figure 8b.
Installing the screen door.
Caution:
■
The screen door must be installed prior to oper
-
ating the heater.
Cautions:
■
If logs are not placed properly, excessive sooting
will result.
■
The surface of the logs will crack due to the heat from
the flames. This is a normal occurance.
■
The use of ember material is strictly prohibited.
Log 'C'
Log 'B'
Installing the Logset
Installing the Logs:
The
24VF
is supplied with a two-piece fibre logset. The logset is very
fragile and must be handled very carefully.
1.
Remove the screen door as shown in figure 8a.
2.
To install the logs, place the rear log in place on the rear log rest.
Ensure that the log is centered in place as shown below. Place the
front log in place on the front logrest and center it in place.
3.
Re-install the screen door before operating the fireplace.
If there is any evidence of carbon or blackening on the logs
from direct contact with the fire, they may be installed incor
-
rectly. Refer to the illustration and correct immediately.
Figure 9b.
Positioning for the logset.
Re-Installing the Door:
Install the screen door by aligning the top edge in place underneath
the heat baffle. Slide the door up and then rest it down into place
behind the lower door rail, as shown below.
Figure 9a.
24VF's two piece logset.
Rear Log
Front Log
Removing the Logs:
Remove the door and carefully remove the logs from the logrests.
Handle the logs very carefully.
