Switching the Console from MPH to KM
E51
Once you insert the batteries into the back of the console, the console will be
set to mph. To switch from mph to km, press and hold the select button for
three seconds. While holding the select button down, the time on the
console will begin to increase. Once the select button is held for three
seconds, the time will reset to zero. Continue to hold the select button for
two additional seconds. Again the time will begin to increase but will reset
to zero once the select button is held for two seconds. The console is now
set for km. To switch back to mph, simply remove the batteries and replace.
Note:
To verify speed setting, upon powering up console, look for a 0 or 1
in the upper right hand corner of display. 0 represents Miles and 1
represents KM.
Programmable Resistance (Except 4.1E)
The back of the console features a switch to convert the speed readout from
mph to km. To convert from mph to km, simply flip the switch. Please note
that the console needs to be reset before the change will be detected.
Note:
To verify speed setting, upon powering up console, look for a 0 or 1
in the upper right hand corner of display. 0 represents Miles and 1
represents KM.
4.1E
Press Resi/- buttons simultaneously for a few seconds to get into
Engineering Mode. Press Select to change Engineering Mode to ENG4.
Press Start to enter ENG4. Once in this mode, press select to toggle between
Miles and KM. Once correct speed setting is selected, press and hold Stop
to exit ENG4.
Note:
To verify speed setting, upon powering up console, look for MI or KM
to flash briefly on display.
17
