Noise Internally While Pedaling at Higher
Resistance Levels Only
Possible causes:
1. Crank pulley wheel is rubbing against the side of the brake assembly.
2. Brake assembly is rubbing against the flywheel.
Fix:
1. Remove the side covers and manually spin the flywheel. Confirm that
there is approximately a 3mm gap between the crank pulley wheel and
the side of the brake assembly. If the crank pulley wheel is rubbing
against the brake assembly, manually push the brake assembly in the
appropriate direction. Verify that the proper gap has been achieved.
2. Remove the side covers and verify that there is approximately a 3mm
gap between the entire magnet surface of the brake assembly and the
flywheel. If the brake assembly is rubbing against the flywheel,
adjust the position of the brake assembly. Reference
replacing/adjusting the brake assembly in the table of contents.
26