Replacing the Elliptical Crank Assembly
Tools:
Phillips screwdriver, 13mm socket, 14mm socket, 17mm wrench,
5mm Allen wrench, crank puller, snap ring pliers, rubber mallet, bearing
Loctite.
1. Remove the 13mm nut and associated bolt that attach the lower
handlebar to the lower link arm.
2. Remove the 5mm bolt that attaches the right lower handlebar to the
left pedal arm.
3. Remove the crank arm cover from the right pedal arm with a Phillips
screwdriver.
4. With a 17mm wrench, remove the nut that attaches the right pedal arm
to the crank axle. Remove the pedal arm from the crank axle.
5. Remove the black cap (Q17) from the center of the crank disk.
6. Remove the crank arm nut (R11) with a 14mm socket.
7. Thread a crank puller onto the crank arm (AJ1). Extract appropriately
and remove the crank arm and crank disk from the crank axle.
8. Lift console mast boot.
9. Remove the accent piece (Q16) by gently lifting up at the bottom of
the accent piece and tilting forward.
10. Remove the screws that attach the right side cover (Q01) in place.
11. Repeat steps for left side.
50