BEFORE
YOU
BEGIN
12
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY
STEP
GUIDE RAIL
SPACER RINGS (I)
LOWER HANDLEBAR
NUT (K)
BOLT (G)
LOWER LINK ARM
SPACER (H)
LOWER LINK ARM
SPACER
TEFLON WASHERS
LOWER
HANDLEBAR
WASHER (J)
LOWER LINK ARM
A) Open
HARDWARE BAG FOR STEP 7.
B) Slide
SPACER (H)
into
LOWER LINK ARM.
C)
Place
SPACER RINGS (I)
on both sides of
SPACER (H).
While holding
SPACER RINGS (I),
slide
LOWER LINK
ARM
into bottom end of
LOWER HANDLEBAR
.
D) Insert
BOLT (G)
into
LOWER HANDLEBAR
and secure using
WASHER (J)
and
NUT (K)
.
E) Repeat on other side.
NYLON NUT (K)
INSIDE DIAMETER:
8 mm
Qty: 2
BOLT (G)
45 mm
Qty: 2
SPACER (H)
28 mm axis
Qty: 2
SPACER RING (I)
20 mm
Qty: 4
WASHER (J)
18 mm
Qty: 2
HARDWARE BAG FOR STEP CONTENTS :
ASSEMBLY
STEP 6
LEFT HANDLEBAR
PRE-ATTACHED BOLT AND WASHERS
RIGHT HANDLEBAR
RESISTANCE WIRES
NOTE:
There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove
PRE-ATTACHED BOLT & WASHERS
from
CONSOLE MAST.
B) Slide
LEFT HANDLEBAR
onto
CONSOLE MAST
and attach by re-inserting
PRE-ATTACHED BOLT & WASHERS.
C) Repeat on other side.
D) Connect
RESISTANCE WIRES
from the
RIGHT HANDLEBAR
to the wires from the
MAST
.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
E6_Rev.1.2.indd 12-13
8/7/06 4:43:36 PM
