(6)
1-2
Control Panel Screen Descriptions
1
2
3
5
6
7
8
9
10
11
12
13
14
15
16
4
Step Delete Button
When this button is pressed, the step displayed in the middle of the list is deleted.
Step Insert Button
When this button is pressed, the step displayed in the middle of the list moves down and a new step is
inserted into the program.
Cut Memorizing Button
After setting the backgauge to teh desired position, press this button (image reverses to black), and then cut
the sheets. The cutting length will be entered into memory for the step. By doing this for each step, a cutting
program can be created automatically.
Read Button
When this button is pressed, the current position of the backgauge is entered into the step.
Start Button
After the setup is complete, press this button. The Program Cutting Screen appears and the program can be
used.
Step Number Input
When this is pressed, the Numeric Keypad Screen appears. Enter the
number of the step you want to show, and that step will be displayed.
Cutting Length Input
Enter the cutting length for the step. If you are using the repeat function, enter the cutting width here.
Push-out Button
: After the sheets are cut, they will be pushed out by the backgauge.
: After the sheets are cut, they will not be pushed out.
Repeat Button
: After cutting the sheets, the program does not proceed to the next step, and the backgauge moves into
position to cut the sheets again by the same cutting width.
: After cutting the sheets, the cutting operation proceeds to the next step.
Repeat Frequency Input
If repeat has been selected , enter the number of times the step should be repeated.
If "0" is entered, the machine will continue to repeat the same cut.
Program Number Input
When this is pressed, the Program Select Screen appears.
(See page 8.) On that screen, select the program number
you want recall or save.
Current Length Input
The current cutting length is indicated here. When this
area is pressed, the Numeric Keypad Screen appears.
When the value of the cutting length is entered, the
backgauge moves to that position.
Unit Select Button
Each time this button is pressed, the units used on the
machine change: or
1
2
3
Refer to numbers
through
in Section 1-2-4 "Cutting Mode - Program Cutting Screen."
Cutting Line
Cutting
Length
Cutting Width
4
5
6
7
8
9
13
~
10
12
4
6
14
15
16
mm
inch
Described on the next page
1-2-5 Memory - Programming Screen
This screen is used to create a cutting program, including settings such as cutting
length and other functions, and store them as a program sequence.
Summary of Contents for APC-61 II
Page 1: ......
Page 37: ...30 This page is intentionally left blank...
Page 65: ...58 This page is intentionally left blank...