184
8-6
Thickness Detector TD-200
7
Take the TD-200 until and just
loosen 4 screws that fix the brack-
ets to the bar.
8
Put the TD-200 into the machine,
so that the Laser unit is located
above the reflector nut.
1. Fasten the brackets to both side frames of
FC-200A/200L.
2. Fasten 4 screws that fix the brackets to the
bar.
- Fasten the screws pushing the TD-200
down.
9
Remove the front cover of FC-
200A/200L.
10
Replace the plastic hole cap with
the bush from the kit.
11
Lead the cable of TD-200 through
the bush, and lead it also through
the bush of the electrical control
box.
12
Connect the cable at the lower part
of the P.C. board.
13
Fix the grounding wire to the
frame.
- Use an M4 screw and a tooth washer.
14
Tie the cable of TD-200 to the other
wires by use of nylon ties.
15
Attach the front cover of FC-200A/
200L back again.
11119
80501D1
11119
80501J1
11119
80501E1
11119
80501F1
Screws
Bush
Hole Cap
Front Cover
1
2
11119
80501G1
11119
80501H1
Connect here.
11119
80501I1
Tooth
Washer
M4
2
1
Screws
Bracket
Bracket
Nylon tie
Nylon tie
Nylon tie
Nylon tie
Be sure the cable does not touch any moving
parts in the machine, like belts, shafts or
rollers.
CAUTION
Summary of Contents for Bookletmaker FC-200A
