130
6-7
Clincher Point Replacement
If the clincher points are worn out, the stitch
may not be bent enough.
Replace the clincher points when they are
worn out.
1
Remove the clincher.
2
Pull down the pusher.
3
Turn each clincher point upward
and pull it out.
4
Attach the new clincher point.
5
Insert the pusher.
6
Attach the clincher.
- Hook the pusher on the push bar.
- Align the clincher with the stitcher head.
(Use the positioning gauge in the accesso-
ries.)
Refer to section 6-9 for using the positioning
gauge.
11119
60701A1
11119
60701B1
Pusher
11119
60701C1
Be careful not to drop the nut plate on the rear
side.
If both clincher points are turned upward at the
same time, they may hit each other. Remove
one clincher point at a time.
22
22
22
11119
60701D1
Clincher Point (Black)
Clincher Point Fulcrum
Shaft
The part mounts here.
11119
60701E1
11119
60701F1
1 3 5 7
-L- 0 2
11119
60701G1
Clincher
Box
Bender
Push Bar
11119
60701H1
Pusher
Summary of Contents for Bookletmaker FC-200A
