187
Thickness
Detector TD-200
Opt
io
ns
8
8-6
Thickness Detector TD-200
8-6-3 Operation
1
Set up the job on the Setting
screen and do the changeover.
- Refer to 3-2 to 3-5 for details.
- The width of booklet which can be detected
by the TD-200 is 185 mm (7.285") or wider.
- The TD-200 measures the height of clamp
when trimming the booklet. Therefore, the
knife and clamp are operated even a job
without trimming when the thickness detec-
tion function is active. In this case, the finish-
ing fore-edge dimension is set 2 mm (0.08")
wider than booklet length.
If the booklet is still trimmed, adjust the stop-
per again.
2
Turn on the thickness detector
function on the Status Setting-
Option screen.
3
Set the sensitivity of the thickness
detector in three steps.
- Normally, use it with high sensitivity.
4
Turn on the faulty set eject func-
tion to eject a booklet with thick-
ness error to the faulty set ejecting
tray.
When the job without trimming and with
thickness detection function, the finishing
size is 248 mm (9.760") at maximum.
This thickness detector function can be
used only when the "saddle stitch" or "fold
only" is selected.
21102
80603A1
low
OFF
OFF
ON
ON
OFF
ON
high
21102
80603B1
Sensitivity
Summary of Contents for Bookletmaker FC-200A
