14
1-3
Screen Descriptions
1-3-3 Setting-Finishing Size Screen
Stitch Distance
For Saddle Stitching
The “stitch distance” is the distance between the centers of the stitches. Set the stitch distance as listed below:
When top and bottom distance is 185mm (7.285") or more
- 79.1 to 92.0 (mm)
- 138.0 to 150.9 (mm)
- 234.0 to 246.0 (mm)
- 3.860” to 5.905”
If the top-to-bottom distance is less than 185mm (7.285")
- 79.1 to 80.9 (mm)
If the stitch distance is adjusted outside this range, skewing may occur because the stitch hits the fold knife, or the crooked trimming
may occur because the stitch hits the booklet stopper. If a value outside the normal range is entered, the value is shown in red and the
caution icons(
) are displayed.
On a machine set to measure in inches, you must set the stitch distance carefully so that the stitches do not hit
the fold knife or booklet stopper.
Stitch distance so that the stitch does not hit the fold knife
- 3.860” to 5.905”
Stitch distance so that the stitch does not hit the booklet stopper
- 3.115” to 3.185”
11119
10303C1
21102
10303A1
11119
10303B1
Finishing Size-Saddle Stitch Screen
Finishing Size
Press one of these buttons for standard size sheets, and
the dimensions are entered automatically.
Stitch Type
Select a stitch type from one of the five styles.
Depending on the sheet size, some stitch types may not be
available.
Press this button to do fore-edge trimming.
This icon blinks if the HOF-20/30
connected upstream of the SPF-
200A/200L has a problem.
Booklet Thickness
Measure the thickness using a caliper (accessory),
and enter the value. The allowable range is 0.1mm
(0.005") to 4.0mm (0.155”).
The fold roller gap and the height of the
fore-edge transport belts are adjusted
automatically to match this value.
Top-to-Bottom Distance
= Flat Stitch
= Loop Stitch
=
No changeover is performed and the
Binding screen is displayed.
=
Each mechanism returns to the home
position and then starts the changeover.
=
The machine starts the changeover without
sending the parts to the home positions.
The actual positions of the guides and stoppers may be
different from the set positions. If there is a problem with
the binding quality, send all of the parts to the home posi-
tions before doing the changeover.
1-3-3
Setting-Finishing Size Screen
Summary of Contents for Bookletmaker FC-200A
