60
3-5
Confirming the Status Settings
This section only describes the status set-
tings you must make before every binding
operation. There may also be other status set-
tings which are not mentioned here.
1
Display the Binding-Status Setting
screen.
2
Select
if the support guide
is used in the VAC.
The Caution screen is displayed.
- Press
to start the changeover.
3
Select
when using the
faulty set ejecting function.
4
Select
when using the wire
feeding detect function.
5
To do manual feeding or feeding
from the HMU (the manual feed
unit of the optional VAC), select
the proper icon.
= No manual feeding
= Only manual feeding
= When the HMU is used (Hand
Marry Unit of the collator). This
function cannot be selected on the
screen. This function can only
selected using a switch on the
HMU.
= Feeding starts from the collator
after sheets are loaded in the man-
ual feed section. (Production speed:
Slow)
= The sheets are fed manually to
match the feeding from the collator.
(Production speed: Fast)
= The sheets are fed manually under
the sheets fed from the collator.
To do manual feeding, go to Section 3-7.
11119
30501A1
21102
30501B1
21102
30501C1
2
2
3
3
4
4
5
5
Caution Screen
Status Setting-Collator/Faulty Set Detect/Manual
Feed/Stitch Screen
If the wire has almost run out, the sensor may turn
off even though the wire is still feeding correctly. If
this happens, press
.
Summary of Contents for Bookletmaker FC-200A
