6
7
HARDWARE foR STEP 1-1
:
ASSEMBLY
STEP 1-1
(T3000 ONLY)
ASSEMBLY
STEP 1-1
(T3000 ONLY)
T
3000
ONLY
T
3000
ONLY
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
RIGHT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
LEFT CONSOLE MAST
BOLT (A)
M8x20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
Φ
8.2x
Φ
17 mm
Qty: 6
SCREW (D)
Φ4x
20 mm
Qty: 4
* This step is for T3000 models only.
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open
hardware for step 1
.
C Slide
main frame boot
up
console mast
.
Pull
lead wire
through
right console mast
.
After pulling the
lead wire
through the mast, the
top of the
console cable
should be located at
the top of the mast. Detach and discard
lead wire
.
D Place
right console mast
over
main frame
bracket
.
E Attach
console mast
to
main frame
bracket
using 3
bolts (a)
, 3
spring
washers (b
) and 3
arc washers (c)
.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
SCREW (D)
MAIN FRAM BOOT
F Slide
main frame boot
down over
main frame
bracket
.
g Repeat steps D–F on other side.
H Attach
main frame boots
to main frame using
4
screws (d)
.
(T3000)
(T3000)
