BEFORE
YOU
BEGIN
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
IMPORT
ANT
PRECAUTIONS
A) Open
HARDWARE BAG FOR STEP 2.
B) Carefully pull the
CONSOLE CABLE
through the
CONSOLE MAST
using the twist tie located inside the
CONSOLE MAST
.
C) Attach the
CONSOLE MAST
to the
MAIN FRAME
using 4
BOLTS (A),
4
SPRING WASHERS (B)
and 4
FLAT
WASHERS (C).
D) Attach the
TOP FRONT COVER
, followed by the
TOP BACK COVER
and snap them together.
E) Slide
CONSOLE MAST BOOT
down to seal the console mast hole.
ASSEMBLY
STEP
CONSOLE MAST
CONSOLE MAST BOOT
MAIN FRAME
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
TOP FRONT COVER
TOP BACK COVER
CONSOLE MAST BOOT
CONSOLE WIRE
#0-5 "
NN
2UZ
413*/(8"4)&3 #
NN
2UZ
'-"58"4)&3 $
NN
2UZ
HARDWARE BAG FOR STEP 2 CONTENTS :
ASSEMBLY
STEP 2
PEDAL ARM
PEDAL ARM TUBE
TEFLON WASHERS (E)
BOLT (G)
FLAT WASHER (F)
LOWER LINK ARM
LINK ARM BRACKET
SPACER (D)
A ) Open
HARDWARE BAG FOR STEP 3.
B) Align the bracket on the
LEFT LOWER LINK ARM
with the tube on the
LEFT PEDAL ARM
.
C) Slide the
SPACER (D)
through the
LINK ARM BRACKET
and the
PEDAL ARM
so it can’t rotate.
D) Insert 2
TEFLON WASHERS (E)
between the
PEDAL ARM
and the
LINK ARM BRACKET
.
E) Secure the joint with a
FLAT WASHER (F)
and
BOLT (G)
.
F) Repeat on the other side.
BOLT (G)
15 mm
Qty: 2
SPACER (D)
70 mm axis
Qty: 2
FLAT WASHER (F)
35 mm
Qty: 2
SPLIT TEFLON WASHER (E)
30 mm
Qty: 4
HARDWARE BAG FOR STEP CONTENTS :
EX-57_Rev.1.3.indd 8-9
6/25/08 10:40:31 AM
