INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
PRE-ASSEMBLY
ASSEMBLY
STEP 2
ASSEMBLY
STEP 1
Open
HARDWARE BAG 2
.
Slide the left
CONSOLE MAST
down onto the
CONSOLE MAST
SUPPORT TUBE
. Bolt in place
using 2
BOLTS (B)
, 2
SPRING
WASHERS (C)
, and 2
FLAT
WASHERS (D)
on the side
.
Then,
bolt in place using
2
BOLTS (B)
,
2
SPRING WASHERS (C)
, and 2
ARC
WASHERS (E)
on the front
.
Repeat on the other side.
Note: On
RIGHT
CONSOLE MAST
,
the
CONSOLE WIRE
must be
threaded through the mast.
A
B
C
BOLT (B)
15 mm
Qty: 8
SPRING WASHER (C)
15 mm
Qty: 8
FLAT WASHER (D)
15 mm
Qty: 4
ARC WASHER (E)
17 mm
Qty: 4
HARDWARE BAG 2 CONTENTS :
NOTE:
Be careful not to pinch any wires
while assembling the masts.
RIGHT CONSOLE MAST
CONSOLE MAST
SUPPORT TUBE
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
BOLT (B)
SPRING WASHER (C)
ARC WASHER (E)
CONSOLE CABLE
(THREAD THROUGH
INSIDE HOLE IN MAST)
Open
HARDWARE BAG 1
.
Slide the left frame extension
tube onto the console mast
support tube. Bolt in place
using 2
BOLTS (A)
on the side
.
Repeat on the other side.
A
B
C
BOLT (A)
15 mm
Qty: 4
HARDWARE BAG 1 CONTENTS :
FRAME EXTENSION TUBE
CONSOLE MAST SUPPORT TUBE
BOLTS (A)
NOTE:
Do not completely tighten any
screws or bolts until step 5 is complete!
T90_Rev.1.5.indd 8-9
9/10/08 4:21:01 PM
