10
EN
Startup LED Codes
1 second
1 second
Sequence
Initialization failed
Pulsing red
IMU initialization
Red, green and blue fl ash once
Fully charged battery
Green (~2 second duration)
Fully discharged battery
Red (~2 second duration)
Return to home mode activated
Rapid red fl ashing
The quadcopter is in Bind mode
Rapid blue fl ashing
Emergency mode
(cycle power to reinitialize)
White fl ashing
Partial battery charge
Color indicates level of battery charge
(~2 second duration)
1 second
The motors will beep under the following conditions:
• Any time the props stop spinning after they have
been initialized.
• After 30 seconds of no throttle input
(waiting armed on the ground).
Audible Alerts and LED Codes
Audible Alerts
Initialization Audible Alerts
Event
Audible Alert
ESC power on
one short beep
Successful initialization
many continuous tones with increasing frequency
RC signal detected after start
one long tone
Bind detected
one long tone
Bind accepted (3 seconds after detected)
one long tone
Throttle stick in correct position for motor start
low, med, high (happy tone)
Cannot start motors because of low voltage
high, med, low (sad tone)
Cannot start motors because vehicle is tilted
high, med, low (sad tone)
Enter ESC ID assignment mode
loud high, low — high, low
GPS Lock Acquired/Lost
3 short beeps, pause, then 3 short beeps
Event
Audible Alert
Gyro, accelerometer sensor error
High, low, 1 short tone
Compass initialization error
High, low, 2 short tones
Pressure sensor initialization error
High, low, 3 short tones
GPS initialization error
High, low, 4 short tones
ESCs not detected
High, low, 6 short tones
Settings saved (i.e. when changed GPS on/off, etc)
Rapid low, med, high — low, med, high
Low-battery warning
Medium frequency, loud tone (every 3 seconds)
Emergency state warning
(also after ESC ID assignment)
Once per second loud medium tone
Summary of Contents for Blade 350 QX2
Page 1: ...Instruction Manual ...
