Horizon Hobby Blade 350 QX2, Instruction Manual

13

EN

Flight Guidelines and Warnings

•  Always keep aircraft in sight and under control.

•  Always keep people and pets at least 35 feet (10 meters) away when the 

battery is connected.

•  Keep children out of the vicinity of this product at all times.

•  Always use fully charged batteries.

•  Always keep transmitter powered on while aircraft is powered. 

•  Always remove batteries before disassembly.

•  Always keep moving parts clean.

•  Always keep parts dry.

•  Always let parts cool after use before touching.

•  Always remove batteries after use.

•  Never operate aircraft with damaged wiring.

•  Never touch moving parts.

Preparing the 350 QX2 For Flight

CAUTION:

 When the home location is set (

step 6

), the 350 QX2 must be approximately 16 feet (5 meters) from where the pilot will stand during fl ight, point-

ing away from the pilot. If the aircraft is pointed in any other direction, the 

SAFE Circle

 feature will not function as expected and may result in personal injury 

or damage to property. Once the aircraft’s motors are started, do not change your position.

1.  Power on the transmitter with the fl ight mode set to 

Smart Mode 

and the throttle stick down.

2.  Install a charged battery, plug it in and close the hatch.
3.  With the quad on a level surface, turn on the power 

switch and allow the 350 QX2 to initialize.
If the GPS is enabled, wait for the GPS signal to be
acquired, which is indicated by a solid green LED. It 
may take from 30–90 seconds to acquire a GPS signal.

IMPORTANT:

 While in 

Smart Mode

 the motors will not 

start if a GPS signal has not been acquired.

4.  Move the aircraft to the desired home location and

orient the aircraft pointed away from the pilot.

5.  Step back approximately 16 feet (5 meters) from the 

home location.

6.  When you are prepared to fl y, you have two options to 

start the motors:

• Move the rudder stick full left, then full right, then 

back to center.

• Move both sticks into the bottom inside corners, 

then back to center.

7.  The props will begin to spin. The home position for GPS 

functions is set and your aircraft is ready to fl y. 

Lower the throttle stick and hold the bind button for
1 second to power off the props after fl ight.

16 feet (5 meters)

350 QX2 home location

Pilot location

SAFE Circle

™

Smart Mode Flying

Front

LED