14
EN
Flying the 350 QX2
Takeoff
Increase the throttle slightly above low stick (10–15%).
The 350 QX2 altitude in
Smart Mode
corresponds
to the throttle position. Low throttle is on the ground,
slightly raising the throttle will produce a low hover,
and the higher the throttle position, the higher the 350
QX2 will ascend until it reaches its maximum altitude
(approximately 45 meters).
Explore the fl ight envelope of the 350 QX2 in
Smart
Mode
without fear of losing orientation. See the
diagrams in the
Flight Modes Explained
section for
more details on the aircraft’s function in
Smart Mode.
In
Smart Mode,
the direction the aircraft is pointing
does not affect the control, and the aircraft’s response
relative to you (
the pilot location
) does not change with
orientation.
AP Mode
and
Stability Mode
operate more
like a conventional RC helicopter or multicopter.
Maximum altitude
(approximately 45 meters)
Intermediate altitude
On the ground
Full throttle
Half throttle
Low throttle
Mode 2 shown
Smart Mode Altitude Control
Return Home
• When this feature is activated, the 350 QX2
will fl y back to its assigned home location
and land. After landing, the motors may take
up to 5 seconds to disarm. If the motors take
more than 20+ seconds to disarm, perform
the Pressure Sensor Calibration.
• To restart the props after landing in
Return Home,
fully lower the throttle, then quickly move the rudder
stick fully left and then fully right.
CAUTION:
The 350 QX2 will not recognize the
SAFE Circle
feature when
Return Home
is used.
Activating
Return Home
may cause the 350 QX2 to
fl y directly over the pilot if the aircraft was fl own to a
position behind where the pilot was standing when the
home position was established.
Switch to position 1.
Returning the switch to position 0
will stop the
Return Home
program.
Landing
To land the 350 QX2 there are two options:
• Guide the aircraft to where you wish to land and re-
duce the throttle. Hold the bind button for 1 second
after landing to disarm the motors.
• Activate the Return Home function to return the
350 QX2 to the assigned home location and land
automatically.
CAUTION:
Do not activate the
Return Home
function if the 350 QX2 is showing the low
battery indication.
Manually land the aircraft
immediately.
After Your Flight
1. Turn off the power switch on the 350 QX2.
2. Turn off the power to your transmitter.
3. Unplug and remove the battery from the 350 QX2.
CAUTION:
Always disconnect the Li-Po battery from the aircraft when
not fl ying to avoid over-discharging the battery. Batteries discharged to a
voltage below the lowest approved voltage may become damaged, resulting in
loss of performance and potential fi re when batteries are charged.
Location alert
The motors will beep under the following conditions:
• At any time the props stop spinning after they have been initialized.
• After 30 seconds of no throttle input (waiting armed on the ground).
This will alert the pilot to the location of the aircraft if it lands in a location with
low visibility.
Beeping will continue until the battery can no longer supply enough power to the
motors.
If the quadcopter crash lands and one or more motors are stopped by an
impact, the quadcopter enters emergency mode. The LED will fl ash white and
the motors will beep loudly.
RTF
Activating Return Home
Summary of Contents for Blade 350 QX2
Page 1: ...Instruction Manual ...
