EN
Carbon-Z Cub SS
20
Troubleshooting Guide
Problem
Possible Cause
Solution
Oscillation
Damaged propeller or spinner
Replace propeller or spinner
Imbalanced propeller
Balance the propeller.
Motor vibration
Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver
Align and secure receiver in fuselage
Loose aircraft controls
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Worn parts
Replace worn parts (especially propeller, spinner or servo)
Irregular servo movement
Replace servo
Inconsistent flight
performance
Trim is not at neutral
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
Sub-Trim is not at neutral
No Sub-Trim is allowed. Adjust the servo linkage
Aircraft was not kept immobile for 5
seconds after battery connection
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep the
aircraft still for 5 seconds
Incorrect response
to the AS3X Control
Direction Test
Incorrect direction settings in the
receiver, which can cause a crash
DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly
Troubleshooting Guide AS3X
Problem
Possible Cause
Solution
Aircraft will not
respond to throttle
but responds to other
controls
Throttle not at idle and/or throttle trim too high
Reset controls with throttle stick and throttle trim at lowest setting
Throttle servo travel is lower than 100%
Make sure throttle servo travel is 100% or greater
Throttle channel is reversed
Reverse throttle channel on transmitter
Motor disconnected from ESC
Make sure motor is connected to the ESC
Extra propeller noise
or extra vibration
Damaged propeller and spinner, collet or motor
Replace damaged parts
Propeller is out of balance
Balance or replace propeller
Prop nut is too loose
Tighten the prop nut
Reduced flight
time or aircraft
underpowered
Flight battery charge is low
Completely recharge flight battery
Propeller installed backwards
Install propeller with numbers facing forward
Flight battery damaged
Replace flight battery and follow flight battery instructions
Flight conditions may be too cold
Make sure battery is warm before use
Battery capacity too low for flight conditions
Replace battery or use a larger capacity battery
Aircraft will not enter
bind mode or initialize Aircraft receiver is not level.
Raise tail wheel to make the fuselage close to level and hold steady until aircraft
enters bind mode or initializes.
Aircraft will not Bind
(during binding) to
transmitter
Transmitter too near aircraft during binding process
Move powered transmitter a few feet from aircraft, disconnect and reconnect
flight battery to aircraft
Aircraft or transmitter is too close to large metal
object, wireless source or another transmitter
Move aircraft and transmitter to another location and attempt binding again
The bind plug is not installed correctly in the bind port
Install bind plug in bind port and bind the aircraft to the transmitter
Flight battery/transmitter battery charge is too low
Replace/recharge batteries
Bind switch or button not held long enough during bind
process
Power off transmitter and repeat bind process. Hold transmitter bind
button or switch until receiver is bound
Motor turning the
wrong direction
Wires may be incorrectly connected to ESC.
Change any two of the wires to the motor. Or use Forward programming to change
direction of motor.
