EN
9
D
G
J
A
B
Model Assembly
(Continued)
Wing Installation
Before each flight, ensure all wing connectors and fasteners are secure.
Assemble both wings using the following steps. (Only the right wing shown)
1. Install 6 vortex generators (
A
) in the wing channels (
B
) by using the installed
double-sided tape.
2. Install the jury strut (
D
) on the wing mounts using 2 screws (
E
) and
2 lock nuts (
F
).
TIP:
DO NOT overtighten lock nuts on the screws. Ensure the vertical brackets
can pivot freely on the wing mounts.
3. Install the wide front strut (
G
) on the front strut mounts using a screw (
H
) and
lock nut (
F
).
4. Install the narrow rear strut (
J
) on the rear strut mount using a screw (
H
) and
lock nut (
F
).
TIP:
DO NOT overtighten lock nuts on the screws. Ensure the struts can pivot
freely in the strut mounts.
5. Attach the vertical bracket to the struts using 2 pins (
I
) and 2 R-clips (
K
).
(
E
) 3 x 12mm
Button head hex machine
Bag F
(
F
) 3 mm
Lock Nut
Bag I
(
H
) 3 x 18mm
Button head hex machine
Bag J
(
F
) 3 mm
Lock Nut
Bag I
Bag L
(
K
)
Bag L
(
I
)
