EN
7
Computerized Transmitter Setup
(DX6 Gen2, DX6e,DX7 Gen2, DX8 Gen2, DX9, iX12, DX18 and DX20)
Start all transmitter programming with a blank model
(do a model reset), then name the model.
Set Aileron, Elevator, and
Rudder Rates to:
HIGH 100%
LOW 70%
DX6
DX6e
DX8
DX9
iX12
DX20
Go to the SYSTEM SETUP
Set MODEL TYPE: AIRPLANE
Go to CHANNEL ASSIGN:
click NEXT to go to Channel Input Config:
GEAR: B, AUX1: I
Go to the FUNCTION LIST
Go to Throttle Cut:
set to Switch H, Position: –100
Resulting in:
Switch H
operates Throttle Cut, position 0 is
normal and position 1 cuts power to the throttle.
Switch B
operates the 3 SAFE modes
(0 beginner/1 intermediate/2 experienced).
Button I
operates PANIC mode.
If using any DSMX transmitter other than the included DXS (3 position gear
switch, RTF only) the radio will have to be configured correctly for the SAFE
system to work properly.
• SAFE Flight mode is selected using Channel 5 signal (high, middle, low)
• Panic mode is selected with Channel 6 signal (high, low)
Refer to your transmitter’s manual for more information about transmitter setup.
If using a 2 position switch for SAFE flight modes, only Beginner and
Experienced modes will be active.
BNF Transmitter Telemetry Setup
If the transmitter that you intend to use with this aircraft is not displaying
telemetry data, visit Spektrumrc.com and update your firmware. With the latest
firmware installed on your transmitter the telemetry option should now be
functional on your transmitter.
Dual Rate
High Rate
Low Rate
Aileron
100%
70%
Elevator
100%
70%
Rudder
100%
70%
The included DSMX
®
full range transmitter features dual rates to allow you to
select the amount of travel that you want from the control surfaces.
SMART
Technology Electronic Speed Control (ESC)
The Habu STS is equipped with an exclusive Smart ESC that can provide a
variety of real-time power system related telemetry data including motor RPM,
current, battery voltage and more to compatible Spektrum AirWare™ equipped
transmitters (including the DX6e and 8e, DX6 and 8 G2, the DX9, iX12 and
others) while you fly.
Access the telemetry data by plugging the ESC into channel 6 on the A3230
Flight Controller. The ESC will send the below information to the flight control
and the information will be displayed on the compatible transmitter.
RPM:
Volts:
Motor:
Throttle:
Fet Temp:
BEC:
0
0.0V
0.0A
0% Output
0%
0.0C
0.0C
0.0A 0.0V
• RPM
• Voltage
• Current
• Throttle
• FET Temperature
• BEC Temperature
Transmitter Setup
Dual Rates
Assemble the Aircraft
Wing Installation
1. Position the wing and fuselage with the bottom side facing up.
2. Align and attach the wing to the fuselage.
3. Secure the wing to the fuselage using the 4 screws. Use two 3 x 15mm
screws for the front and back holes. Use two 3 x 25mm screws for the side
holes.
4. Disassemble in reverse order.
3 X 25mm (2)
3 X 15mm (2)
