EN
Lights
Bind Port
Right Flap
Left Flap
Ailerons
18
Night Timber X 1.2m
With the basic transmitter setup, the ailerons and fl aps will operate separately.
For increased aileron authority, the AR637TA receiver included in the BNF
version may be confi gured so the fl aps can operate as both fl aps and ailerons.
Servo Plug Order Change
1. Remove the Y-harnessed lights from Ch-5 port on the AR637TA
2. Remove the Y-harness plugged into the Ch-6 port on the AR637TA.
3. Insert two servo extensions (EFLREX9L) into the receiver ports; one in Ch-5
and one in Ch-6.
4. The left fl ap plugs into the Ch-5 extension. The right fl ap plugs into the
Ch-6 extension. We recommend labeling the wires to help identify the
correct ports when mounting the wing.
5. Insert the Y-harness into the BIND port. The lights plug into one side of the
Y-harness, and the other side serves as a BIND port.
CAUTION:
Connecting servos to the wrong port on the receiver could
cause a crash.
IMPORTANT:
A 7-channel or higher transmitter is required for the advanced BNF
receiver setup plus the ability to select between AS3X and SAFE with SAFE Select. If
using a 6 channel transmitter for the advanced receiver setup, only AS3X is available.
BNF advanced receiver setup
(optional)
AR637TA advanced receiver setup port assignments
BND/PRG = Y-Harness: Lights/BIND
1 = Throttle
2 = Y-harness: Ailerons
3 = Elevator
4 = Rudder
5 = Left fl ap
6 = Right fl ap
F
G
H
I
J
K
Float Installation
1. Align and mount the fl oat set assembly to the bottom of the fuselage.
2. Secure the back section of the fl oats to the fuselage using the included
bracket (
F
) and 2 screws (
G
).
3. Secure the front section of the fl oats using the two included screws (
H
) to
secure the front support members to the bottom of the fuselage.
4. Attach the included wire from each fl oat rudder (
I
) to the pull–pull horn (
J
)
using the two included pins (
K
).
Disassemble in reverse order.
