EN
P-51D Mustang 1.5m
8
A
B
Optional Drop Tank Installation
The recommended receiver for this aircraft is the Spektrum AR637T. If you
choose to install a different receiver, ensure that it is at least a 6-channel
full range eceiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR637T Installation
1. Slide the canopy latch (
A
) back and lift the back of the canopy to remove
the canopy from the fuselage.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the table at the right.
3. Using double-sided servo tape,(not included) mount the receiver to the fl at
area behind the battery compartment, as shown. The receiver should be
mounted in the orientation shown, parallel to the length of the fuselage,
with the label facing up and the servo ports facing the front of the
aircraft. The orientation of the receiver is critical for all AS3X
®
and SAFE
®
technology setups.
CAUTION:
Incorrect installation of the receiver could cause a crash.
PNP Receiver Selection and Installation
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder/Tail wheel
5 = Retracts
6 = Flaps
A
Drop Tank
Slide the optional drop tanks (
A
) into the rails (
B
) on the bottom of the left and
right outer wing panels.
TIP:
The drop tanks are labeled (L) for left and (R) for right.
Check the Center of Gravity with the drop tanks installed.
See the Adjusting the Center of Gravity instructions for more information.