EN
Factory Settings
Horns
Arms
Elevator
Rudder
Ailerons
Control Horn and Servo Arm Settings
1. Remove the battery hatch from the fuselage using the latch button.
2. Turn over the fuselage so the bottom faces up and install the wires and
connectors through the hole in the fuselage (
A
) to the receiver.
CAUTION:
DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
3. Insert the guide pins (
B
) on the front of the wing in the fuselage plate holes
(
C
), then connect the wing to the fuselage using 2 screws (
D
).
4. Turn the aircraft over to connect the servos and optional connectors to
the receiver or Y-harnesses. The left and right servos can be connected to
either side of a Y-harness.
TIP:
Carefully coil and store the servo wires in the hole in the fuselage for
easier battery installation.
When needed, disassemble in reverse order.
B
A
Wing Installation
C
D
More control throw
Less control throw
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
After fl ying, you may choose to adjust the linkage positions for the
desired control response. See the table below.
7
