5
EN
Ultra Stick PNP
2.
Slide the wheel collar and bracket down and away from the
bottom of the fi n.
RUDDER AND ELEVATOR INSTALLATION
1.
Remove the 3mm nut from the fi n mounting post. Use a
1.5mm hex wrench to loosen the setscrew that secures the
wheel collar on the tail gear wire.
3.
Fit the fi n into position in the fuselage.
4.
Slide the elevator on the fi n mounting posts.
5.
Fit the tail wheel bracket over the rear fi n mounting post.
Thread an M3 locknut on the mounting post.
RECEIVER INSTALLATION
1.
Make the connections from the rudder and elevator servos
to the receiver. Also connect the extensions for the fl aps and
ailerons.
All servo extensions have been provided when
using an eight channel radio. No Y-harnesses will be
required. Mixing at the transmitter will be required.
When using a six channel radio, a Y-harness has
been included for the flaps. Mixing at the transmitter
will be required to operate the ailerons.
Using a five channel radio will require the use of the
included Y-harness for the flaps, and an additional
Y-harness (SPMA3058) for the ailerons.
2.
Secure the receiver in the fuselage. Use the instructions
included with the receiver for additional mounting details.
Make sure none of the wires from the receiver interfere with
the operation of the servos.
3.
Check that the servo arms for the elevator (1) and rudder (2)
are at 90-degrees to the pushrods. Adjust the sub-trim of the
radio or reposition the servo arms as necessary.
4.
Label the extensions for the ailerons and fl aps.
