64
Programming Guide — JR™ XP8103
Trim Display
Pot 5: Flaperon Flap Trim
Pot 6: Dual-Flap Flap Trim
Pot 7: Aileron Trim of Dual-Flap
Press the + or - key
to inhibit or activate
“Trim POT.”
Press either CH key
to select the desired
trim POT.
Press the Clear key to
activate selected Trim POT.
DN
SELECT
CH
CH
CLEAR
UP
→
POT 5
↓
POT 6
↓
POT 7
Each Trim’s Operational Direction
Step 6. Turning off the trim knobs:
In Function mode, press
the
Up
key until the “D/FLAP T”. (dual flap trim) screen appears.
Pressing the
CH
key will advance through the three available trim
pots: 5, 6 and 7. Inhibit all three by pressing the (+) key when
each one is selected. This will prevent any unwanted control
movement should the knobs be moved.
Sub-Trim Value
(max ± 125)
Increase or decrease
sub-trim value
(L&R/U&D)
Channel Selection
(press to manipulate
arrow)
Press to reset sub-trim
value to factory preset (0).
Press to display channels
1-4 and 5-8
(2 Screens).
DN
SELECT
CH
CH
CLEAR
UP
Channel Being Programmed
SPOI
Throttle
AILE1
Aileron Left
ELEV
Elevator
RUDD
Rudder
AILE2
Aileron Left
FLAP
Flap (Right)
AUX2
Flap (Left)
Step 7. Adjusting the sub-trims:
Turn on the transmitter and
receiver and center the trims. Move the flap switch in the upper
position. Now reposition all the servo arms so that all the control
surfaces are as close as possible to their neutral positions.
In System Setup mode, press the
Up
key until the “Sub-Trim” screen
appears. Now press the
Channel
key to access the desired channel
and press the (+) or (-) key to perfectly center each control surface.
Press the
Select
key to access the other four channels.
Note:
The throttle is referred to as “SPOI” in the glider model.