EN
7
Instruction Manual
SAFE
®
Select Switch Designation
AS3X Control Direction Test
This test ensures that the AS3X
®
control system is
functioning properly. Assemble the aircraft and bind your
transmitter to the receiver before performing this test.
1. Raise the throttle just above 25%, then lower the
throttle to activate AS3X technology.
CAUTION:
Keep all body parts, hair and loose
clothing away from a moving propeller, as these
items could become entangled.
2. Move the entire aircraft as shown and ensure the control
surfaces move in the direction indicated in the graphic.
If the control surfaces do not respond as shown, do not
fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move
rapidly. This is normal. AS3X remains active until the battery
is disconnected.
To enable and disable SAFE
®
Select Technology use the following steps:
Aircraft
Movement
Control Surface Reaction
(viewed from the rear)
Pitch up
Pitch down
Roll left
Roll right
Mode 1 and 2
Transmitters
x 5
1. Power on transmitter.
2. Connect battery to the airplane and allow it to initialize.
3. Hold sticks in lower inside corners.
4. Toggle the Channel 5 switch five times. The ailerons
will cycle twice, indicating SAFE Select is toggled ON/
OFF.