6
How to Program Your
Fingerprint
The Biometric Safe can store up to
five (5) fingerprints. To program a
fingerprint:
1. Open the Biometric Safe with either
the key or a previously programmed
fingerprint or key code.
2. Locate the red program button.
Press and release the button
to begin programming. The first
available program location will
begin to blink.
3.
Slowly drag finger across the
scanner.
The unit will beep once
after a successful read. If you hear
two beeps or no beeps, try moving
finger slower or more consistently
across the scanner. It will take
at least 3 successful reads (often
more) to program safe.
If the programing sequence is
successful, the latch motor will
activate.
NOTE:
If the user attempts to
program a fingerprint that is already
stored into the safe, the safe will
beep three times and the fingerprint
will not be programmed into the
duplicate slot. Each fingerprint
can only be programmed into one
location.
4. Verify the fingerprint is programmed
by slowly sliding finger over
scanner with the lid open. The
motor should cycle after each scan.
Scanner
