3
RAPiD
®
Safe Setup and Operation
To achieve the best experience with your RAPiD
®
Safe, please read all instructions
carefully, and understand its operation before securing valuables inside the safe.
Open Safe with Key
Before setting up your safe please verify both circular barrel keys fit and unlock your safe.
Contact Hornady
®
at 800-338-3220 if the keys do not work. Store keys in a secure location
outside the safe.
Batteries
Open the safe with the mechanical override key. Remove
the battery cover inside the door. Insert 4 AA batteries
and replace the battery cover. Do not close the door
before testing digital lock.
NOTE:
Replace all batteries at the same time.
How to Program Your RFID Tags
Your RAPiD
®
Safe includes two (2) styles of RFID tags,
including one Watchband Tag and one Decal
*Additional styles can be purchased separately.
The RAPiD
®
Safe can store up to five tags.
To program these tags:
1. Open the RAPiD
®
Safe with either the key or a previously
programmed RFID tag or key code. The safe does not
ship with pre-programmed RFID tags. A RFID tag must
be programmed to work with this safe.
2. Locate the red program button inside the safe. Press
and release the button to begin programming a RFID
tag. The internal light will blink during program mode.
3.
Hold the RFID tag within 1-inch
of the RFID reader
area on the keypad front. If the programming was
successful, the safe should blink and beep two times.
NOTE:
If the user attempts to program a RFID tag that
is already stored in the safe, it will beep three times
and exit program mode.
4. Verify the RFID tag is programmed by holding the tag
over the RFID reader with the door open. The motor
should cycle after each scan.
5. If the RFID tag is not programmed, the program
function will time out after ten seconds and the safe
will return to normal operation. If multiple attempts
to program a RFID tag fail, please contact Hornady
®
at 800-338-3220.
6. One to five RFID tags can be programmed into
the safe.
RFID Reader
Program Button