Program Button
One to five RFID tags can be programmed
into the safe.
6
7
4. Verify the RFID tag is programmed
by holding the tag over the RFID
reader with the lid open. The motor
should cycle after each scan.
5. If the RFID tag does not program
into the safe, the program function
will time out after ten seconds
and the safe will return to normal
operation. If multiple attempts to
program a RFID tag fails, please
contact Hornady at 800-338-3220.
6. One to five RFID tags can be
programmed into the safe.
How to Program Your
RFID Tags
Your RAPiD
®
Safe includes three (3) styles
of RFID tags, including:
• 1 Wristband
• 1 Key Fob
• 2 Decals
*Additional styles and sizes can be
purchased separately.
The RAPiD
®
Safe can store up to 5 tags.
To program these tags:
1. Open the RAPiD Safe with either the
key or a previously programmed RFID
tag or key code. (The key code safe
does not ship with pre-programmed
RFID tags. A RFID tag must be
programmed to work with this safe.)
2. Locate the red program button.
Press and release the button to begin
programming a RFID tag. The first
available program location will begin
to blink.
3.
Hold the RFID tag within 1"
of the
illuminated RFID reader area on the
top of the safe lid. If the programming
was successful, the safe should
beep two times and the available slot
should go from blinking to solid red for
approximately ten seconds.
NOTE:
If the user attempts to
program a RFID tag that is already
stored into the safe, the safe will
beep three times and the RFID tag
will not be programmed into the
duplicate slot. The RFID tag can only
be programmed into one location.
How to Program Your Key Code
A single user defined 4 to 6 digit code can be entered into the RAPiD
®
Safe.
1. Open the RAPiD Safe with either the key or a previously programmed RFID tag
or key code. The safe ships with a default code and should be reprogrammed
before first use.
2. Locate the red program button to begin programming your key code. The first
available tag location will begin to blink to indicate program mode.
3. With the lid open, enter a 4 to 6 digit code into the keypad on the lid. Press the
“H” after entering your code. Verify your code is correct by re-entering your
code and pressing “H”. The motor should cycle.
4. Your key code can now be used to open the safe.
NOTE:
Only one key code can be entered into the safe. If a second code is
entered, it will override the previous code.
**
A total of 5 RFID tags and 1 key
code can be entered into the safe.