7
How to Program Your Key Code
A single user defined 4 to 6 digit code can be entered into the RAPiD
®
Safe Ready Vault
™
.
1. Open the RAPiD Safe with either the key, a previously programmed RFID tag, or key
code. The vault ships with a default code and should be reprogrammed before first use.
2. Locate the red program button to begin programming your key code. The first available
tag location will begin to blink to indicate program mode.
3. With the door open, enter a 4 to 6 digit code on the keypad. Press the “H” after entering
your code. Verify your code is correct by re-entering your code and pressing “H”. The
motor should cycle.
4. Your key code can now be used to open the vault.
NOTE:
Only one key code can be entered into the vault. If a second code is entered, it
will override the previous code.
**
A total of 5 RFID tags and 1 key code can be entered
into the vault.
How to Remove All Tags From Vault
1. Open the RAPiD
®
Safe with either the key, a previously programmed RFID tag, or key
code. Locate the red program button. Press and hold the button for five seconds to erase
all previously programmed tags. All five red LEDs will begin to blink in sequence. The
vault does not allow individual tags to be removed. They must all be erased at one time.
The intended RFID tags can then be reprogrammed with the instructions above.
NOTE:
To abort the erase procedure, press the “H” button on the door of the vault or do
not touch anything and the erase procedure will automatically abort after 10 seconds
and return to normal operation.
Test RFID tags and the key code to confirm they are
operational.
2. To confirm erasing procedure, press and release the program button again. All five LEDs
will blink three times to visually confirm all RFID tags have been removed. The RFID tags
will no longer work until they are reprogrammed with the instructions in the “How to
Program Your RFID Tags” section.
