Owner’s Manual
Under Bed Safe
Item No. 75402
Customer Service: PO Box 1848, Grand Island, NE 68802-1848
1-877-214-4470 | Email: info@snapsafe.com
586006 / REV 1
19SNAP0036 | 09/2019
Ext. Dimensions: 26.0" x 5.0" x 20.0"
Int. Dimensions: 23.5" x 3.5" x 14.3"
LOW BATTERY WARNING
If the batteries become weak, the keypad will remain red during operation.
Replace batteries immediately to ensure proper operation of the safe.
SECURITY CABLE INSTALLATION
There are holes located on both
sides of the safe for installing the
security cable.
1. Loop the cable around a secure
object and then insert the
threaded end of the cable through
the loop of the cable.
2. Remove the plastic plug on the
side of the safe.
3. Open the drawer just far enough
that the hole in the side of the
drawer aligns with the hole in the
side of the housing.
4. Insert the threaded stud into the
side of the safe and install the
nut. NOTE:
The nut only needs
to be tightened until the nylon
thread lock engages.
NOTE:
The drawer can be removed
to make installing the security cable
easier or to permanently bolt down
the safe.
To remove the drawer, fully extend
the drawer and then locate the
small lever inside each drawer
slide. Press up on the right lever
and down on the left lever. With the
levers pressed, carefully pull out the
drawer for removal.
To reinstall the drawer, carefully
align the slides on each side and
then press the drawer in. The levers
should click into place.
Weight: 55 Lbs
Power: 4 AA batteries (not included)
Threaded
Stud
Drawer Lever
Threaded Stud
Inserted in Housing
