1.
Press the
Menu
button and rotate
Control 1
until screen shows
“
Dbl Hdr
”.
2.
Press
Control 1
and rotate until
screen shows “
Dissolve Gp
”.
3.
Press
Control 1
.The screen shows
“
Dissolve Adr: 01
”.
4.
Rotate
Control 1
to show the
Consist you wish to dissolve and
press
Control 1
to confirm.
Dissolving a Double Headed Consist
Fig 1
1.
Press
Menu
key. Screen shows
“
Loco
”.
2.
Rotate
Control 1
until “
Dbl Hdr
”
is displayed on the screen.
3.
Press
Control 1
to confirm. The
Screen will show either “
Dissolve
Gp
” or “
Create Gp
”. Rotate
Control 1
until “
Create Gp
” is
displayed.
4.
Press
Control 1
. Screen shows
“
Create Adr: 01
” as a default
setting.
5.
Decide on an Address / Number
that you wish to have as the
Double Heading number up to a
maximum of 99. For this example
10 has been chosen.
6.
Rotate
Control 1
until 10 is
displayed.Alternatively you can, using
the keyboard type in 10.
7.
Press
Control 1
to confirm. Screen
shows “
Loco 1 Adr: 0010
”.
For more information visit:
www.hornby.com
16
17
Double Heading
Creating a Double Headed configuration (Consist) will require the following procedure. For this example Locos
1 and 2 will be consisted as No. 10. Double Head programming can be done while both locomotives are on the
main circuit.
Please Note:
For both locomotives
to operate in unison it is important
that they each have the same
acceleration and deceleration levels.
5.
Screen will then show in sequence
“
Dissolve Adr: 10
”, “
Adr: 01
”,
“
Adr: 02
”, and finally the screen
will show “
Gp Removed
”. See Fig
1. If an attempt is made to dissolve
a Consist which does not exist the
screen will display “
No Member
”.
6.
The display will return to the main
screen automatically “
Dissolve
Adr:10
”, “
Dissolve Adr: 01
”,
“
Dissolve Adr: 10
”, “
Dissolve
Adr: 2
”.
8.
Rotate
Control 1
or type in the
number of the first locomotive
that you wish to add to the
Consist. For this example No. 1
has been chosen.
9.
Press
Control 1
to confirm. Screen
shows “
Loco2 Adr: 0001
”.
10.
Rotate
Control 1
until the screen
shows “
Loco2 Adr: 0002
”.
11.
Press
Control 1
to confirm. Screen
shows the last locomotive that was
operated.
12.
To control the Consist press the
Loco
key and rotate
Control 1
until Screen shows “
Contr.:1
Adr:0010
”.
13.
Press
Control 1
to confirm. Screen
shows “
00:00 1 0010
”. Rotate
Control 1
both locomotives will
now move.
Elite HBook updated 6.3.07_Q6.qxd 13/3/07 13:09 Page 14
