37
For more information visit:
www.hornby.com
36
1.
Press
Menu
. Screen shows
“
Loco
”.
2.
Press
Control 1
. Screen shows
“
Direct
”.
3.
Rotate
Control 1
until screen
shows “
Operate
”.
4.
Press
Control 1
to confirm.
Screen shows “
Operate
Adr:0003
” or the last locomotive
number operated.
5.
Rotate
Control 1
until screen
shows the number of the locomotive
whose CV you wish to adjust. In this
example number 10 has been
chosen. Press
Control 1
to confirm.
6.
Screen shows “
Config
”. Rotate
Control 1
until “
CV
” is shown and
press
Control 1
to confirm.
7.
Screen shows “
CV Write
”. Press
Control 1
to confirm. Screen shows
“
CV 0001 W
”.
8.
Rotate
Control 1
until “
CV 0003
”
is shown.
9.
Press
Control 1
to confirm. Screen
shows “
CV 0003 W 000
”.
10.
Rotate
Control 1
to adjust the
setting of your choice
1 – 255.
11.
Press
Control 1
to confirm. Screen
shows “
CV
”.
12.
Press
Menu
to return to the main
screen.
Please Note:
The red LED will not flash.
Some CVs can be altered or read in
Operate Mode
which means that the locomotive can be left on the main
line.The procedure to do this is as follows. As an example the Acceleration CV (CV3) will be adjusted.
Changing CVs on the Main Line
1.
Press
Menu
. Screen shows
“
Loco
”.
2.
Press
Control 1
. Screen shows
“
Direct
”.
3.
Press
Control 1
. Screen shows
“
Address
”.
4.
Rotate
Control 1
until screen
shows “
CV
”.
5.
Press
Control 1
. Screen shows
“
CV Write
”.
6.
Rotate
Control 1
until screen
shows “
CV Read
”.
7.
Press
Control 1
. Screen shows
“
CV 0001 R
”.
8.
Rotate
Control 1
until the
screen shows “
CV 0003 R
”.
Should the screen show “
XXX
”
this will denote that the CV could
not be read. If this occurs refer to
the decoder’s specification sheet.
9.
Press
Control 1
.The red LED will
light while the decoder is being
read. Screen shows “
CV 0003 R
”
and the number that CV3 was
programmed as.
The following example is for the reading of CV3 (Acceleration) and must be executed with the locomotive on a
Programming Track.
Reading CVs on Programming Track
Changing and Reading CVs
(continued)
Please Note:
To read CVs it is important that
RailCom
®
is enabled on both the Elite
and the decoder you wish to read.
Note that not all decoders are capable
of having their CVs read. Please refer to
the specification sheet supplied with
the decoder.
Elite HBook updated 6.3.07_Q6.qxd 13/3/07 13:09 Page 34
