RAMBO INSTRUCTION BOOKLET
6
Setting the Throw
It is normal for the clipper forks to lock in position either side
of the throw.
Whichever side the forks are
positioned at, this is the side you
will set the throw from. If the
forks are positioned in the
centre, push your forks to
the right if you are right-handed,
or to the left if you are left-handed.
Adjust the comb so that the outside edge of both the comb and
cutter align. Firmly tighten the comb screws and then turn the
tension knob clockwise to apply tension and secure the cutter
in place.
Setting the Tension
Tighten the tension knob by
turning it clockwise.
Too little tension causes
‘feathering’ which compromises
the quality of the cut.
Too much tension will cause the
comb and cutter to overheat,
resulting in your combs and
cutters becoming blunt faster.
COMB AND CUTTER SET UP
