LMAN0016-01-EN
ETG-A100A INSTALL SHEET
10/28/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
Page
3
of
3
4. WIRING
WARNING
Risk of injury or damage.
LED Remote phosphor light sources achieve full intensity immediately upon being powered on.
Do not look directly at the remote phosphor plate while energized.
Make all electrical connections in accordance with the National Electrical Code and any applicable local
code requirements.
Verify that supply voltage is correct by comparing with the National Electrical code and any applicable
local code requirements.
Driver output connections must use 18 AWG or thicker wiring to the luminaire. Read and follow the rating
and wiring diagram on the LED Driver.
The exposed surface of the remote phosphor panel is a tough, impact resistant polycarbonate. To
maintain efficiency, it
should be cleaned with a mild soap or neutral PH cleaner.
Abrasives or
cleaners containing chlorinated or aromatic hydrocarbons should not be used. Once clean, rinse with
cold water and wipe dry with a soft cloth.
5. TECHNICAL SUPPORT
Tel:
317 916-4274
Fax
: 317 639-4279
Web:
