PAGE
34
20
JUN
2005
WCM802/900
Appendix
A:
Agency
Certifications
FCC Certification
The WCM802 / WCM900 OEM RF Module complies with Part 15 of the FCC rules and regulations.
Compliance with the labeling requirements, FCC notices and antenna usage guidelines is
required.
To fulfill the FCC Certification requirements, the OEM must comply with the following FCC
regulations:
1. The system integrator must ensure that the text on the external label provided with this
device is placed on the outside of the final product [Figure A.1 for 900 MHz operations or
Figure A.2 for 2.4 GHz operations].
2. The WCM802 / WCM900 OEM RF Module may be used only with Approved Antennas that
have been tested with this module. [Table A.1 or Table A.2]
FCC Notices:
IMPORTANT: The WCM900 (900 MHz) and WCM802 (2.4 GHz) OEM Modules have been certified by
the FCC for use with other products without any further certification (as per FCC section 2.1091).
Changes or modifications not expressly approved by Horner could void the user’s authority to
operate the equipment.
IMPORTANT: OEMs must test their final product to comply with unintentional radiators (FCC section
15.107 and 15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.
IMPORTANT: The WCM802 / WCM900 OEM RF Modules have been certified for remote and base
radio applications. If the WCM802 / WCM900 will be used for portable applications, the device must
undergo SAR testing.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
