45
46
47
46a
46b
48
49
50
After shortening the side profiles you can reinsert the corner pieces by placing the upper strip of the mesh/blind
in the upper chamber of the corner piece, while keeping the rest of the mesh/blind underneath (photo’s 45 and 46).
Now connect the corner piece to the base
profile.
Make sure that the corner piece is
placed in the right chambers!
(Photo 46a+b and photo 47)
Push the corner piece to the base profile.
Check if the cords are in the right place
(photo 49). If not: repeat the previous steps.
Overall picture (photo 50).
