16
Theremin Pitch-Bend mode:
The Theremin is able to send Pitch-bend
messages and also note-on/off messages (when triggered with the trigger-
switch, the internal auto-trigger or via external trigger input). Note on/off
message pitch is controlled via the
‘octave’
parameter and the Pitch-Bend
offset (Octave * note-offset). When triggered externally, note velocity is
derived from the trigger signal. Internal triggers derive the note velocity
from the main-volume.
To setup the midi-note-on/off messages for the Theremin, set the mode-
selector to
‘Theremin’
(MIDI) and adjust
‘BEND ( offset ) / OFF’
with
parameter knob
P1
as required.
To disable the pitch-bend mode, just turn parameter
P1
to zero again. The
Theremin Pitch-bend mode has higher (highest) priority over piano-mode
and control-message mode.
Alternative Pitch-Bend note trigger:
When not using the pitch-bend mode
in conjunction with any internal or external triggers, it is possible to
“automatically” trigger a midi-note-on message, whenever the active
Theremin region has been entered (hand near the antenna). In turn, a note-
off message will be send when exiting the active Theremin region (or
antenna mute). Additional note-on messages can be triggered via other
sources as well, if required.
To enable this automatic Note-ON/OFF trigger mode, set the mode-selector
to
‘Instrument’
(MIDI) and adjust
‘BEND note-on msg / OFF’
with
parameter
P1
. This mode is disabled with parameter
P1
set to zero.
Summary of Contents for MIDI Wave-Theremin MWT-01
Page 30: ...29 MODE SELECTION Wave MATRIX...
Page 31: ...30 MODE SELECTION Modulator MATRIX...
Page 32: ...31 SETUP MATRIX...
