(1)
Assembling Process for wall
Step 1
:put 4
Explosive bolt M6*50
①
into the wall.
Step 2:
Take off the nuts, the spring locks washers and the plain washers
from four explosive bolts. Keep them for the next step.
Step3:
Installer the heater on the wall
Complete!
(1)
Assembling Process for wall
Step 1
:put 4
Explosive bolt M6*50
①
into the wall.
Step 2:
Take off the nuts, the spring locks washers and the plain washers
from four explosive bolts. Keep them for the next step.
Step3:
Installer the heater on the wall
Complete!
The heater must be fixed to a wall with the bracket supplied to
allow adequate ventilation.
Never fix or place heater near flammable or combustible
materials.
Generally heaters must be placed at a safe distance (clear space)
of at least 2.0m from combustible materials and glass walls. If
installed in workshops or garages where inflammable or
combustible paints are used, the heaters must be installed at a
distance of at least 4.0m from the source of danger.
If the heaters are placed in areas where spray painting of any
description is taking place, they should not be used during the
painting operations.
Never use the heater in particularly dusty and explosive areas.
Connection to 220-240 Volts Power Supply
It is important to ensure that the electricity supply is of adequate
capacity for the electrical load required by the appliance being
installed.
These appliances must be earthed.
WARNING:
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
Installation
This Heater is built with the best quality components in accordance to
the prevailing legal regulations and certified for safety in use. For best
results from the appliance please ensure that the installation is done
by a qualified electrician in accordance with the following instructions
and taking full account of current regulations. When using the heater,
please carefully follow the instructions and recommendations below.
You could
loosen the two M6*10 screws to
change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
Montering // Installation // Asennus
Væg
Wall
Vägg
Vegg
Seinä
Gulv / Floor / Våning / Gulv / Lattiat
WARNING:
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
Installation
This Heater is built with the best quality components in accordance to
the prevailing legal regulations and certified for safety in use. For best
results from the appliance please ensure that the installation is done
by a qualified electrician in accordance with the following instructions
and taking full account of current regulations. When using the heater,
please carefully follow the instructions and recommendations below.
You could
loosen the two M6*10 screws to
change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
1
2
3
4
5
DA/EN/SE
NO/FI
Loft / Ceilling / Tak / Tak / Katto
Min.
50 cm
12
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
4
Remote control
1
5
W
ire cable
2
Installation
Heater ZHQ
1592
-C
W
-RMis built with the best quality components in
accordance to the prevailing legal regulations and certified for safety
in use. For best results from the appliance please ensure that the
installation is done by a qualified electrician in accordance with the
following instructions and taking full account of current regulations.
When using the heater, please carefully follow the instructions and
recommendations below.
You could loosen the two M
6*
10 screws to change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
4
Remote control
1
5
W
ire cable
2
Installation
Heater ZHQ
1592
-C
W
-RMis built with the best quality components in
accordance to the prevailing legal regulations and certified for safety
in use. For best results from the appliance please ensure that the
installation is done by a qualified electrician in accordance with the
following instructions and taking full account of current regulations.
When using the heater, please carefully follow the instructions and
recommendations below.
You could loosen the two M
6*
10 screws to change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
(1)
Assembling Process for wall
Step 1
:put 4
Explosive bolt M6*50
①
into the wall.
Step 2:
Take off the nuts, the spring locks washers and the plain washers
from four explosive bolts. Keep them for the next step.
Step3:
Installer the heater on the wall
Complete!
(1)
Assembling Process for wall
Step 1
:put 4
Explosive bolt M6*50
①
into the wall.
Step 2:
Take off the nuts, the spring locks washers and the plain washers
from four explosive bolts. Keep them for the next step.
Step3:
Installer the heater on the wall
Complete!
Min. 180 cm
Min. 50 cm
WARNING:
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
Installation
This Heater is built with the best quality components in accordance to
the prevailing legal regulations and certified for safety in use. For best
results from the appliance please ensure that the installation is done
by a qualified electrician in accordance with the following instructions
and taking full account of current regulations. When using the heater,
please carefully follow the instructions and recommendations below.
You could
loosen the two M6*10 screws to
change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
1
2
3
4
5
Part. no. / Del nr.
Material nummer
Osa numero
Qty / Stk.
St. / Kpl.
Dimension
Ulottuvuus
1
4 M6x50 mm
2
1 M6
3
1
4
1
5
2
