Model no.
ZHQ1592-CW-RM
Varenr.
211-357
Strømkilde
230V AC ~ 50 Hz
Strømforbrug
1500W
Kapslingsklasse
IP66
Produktspecifikationer
Garanti
Produktgarantien er i henhold til købeloven. Garantiperioden starter den dag produktet er blevet købt.
Garantihåndtering
Et fejlbehæftet produkt skal returneres til købsstedet sammen med en gyldig kvittering. Hvis produktet får
en fejl i løbet af garantiperioden, skal produktet returneres til købsstedet.
Fraskrivelse af garanti
Skade eller defekter der opstår ved mislighold, eller ved ukorrekt brug af produktet, dækkes ikke af ga-
rantien. Garantien dækker heller ikke force majeure, som lynnedslag, oversvømmelse, ildebrand eller
skader sket under transport. Garantien vil bortfalde, hvis der på nogen måde er foretaget modifikationer på
produktet, eller hvis produktet er forsøgt repareret af en udenforstående tredjepart.
3
Justering af vinklen
BRUGSANVISNING
Monter terrassevarmeren som vist på side 12.
1.
Tilslut terrassevarmeren til en 230V ~ 50Hz stikkontakt.
2.
Brug kun terrassevarmeren, når den er monteret som vist på side 12.
3.
Juster vinklen som vist nedenfor (fig. 1).
4.
Aktivér/deaktivér terrassevarmeren ved at tænde/slukke for ON/OFF knappen som vist nedenfor (fig. 2).
5.
Tryk på ON/OFF-knappen på kontrolpanelet (fig. 3) for at tænde eller slukke for terrassevarmeren eller
6.
brug den medfølgende fjernbetjening til at tænde eller slukke for terrassevarmeren (fig. 4).
Sluk terrassevarmeren enten på kontrolpanelet (fig. 3) eller fjernbetjeningen (fig. 4) samt på ON/OFF
7.
knappen (fig. 2), når den ikke er i brug.
flammable dust.
28.
The heater is at high temperature when in use. Unplug the
heater and wait until it cools down before cleaning.
29.
Don’t use this heater in place where causticity or volatile air
exists, such as dust, steam, gas, etc.
30.
Don’t use this heater as a cloth drier or towel drier.
31.
Don’t use this heater as a sauna heater.
32.
Don’t use this heater in place of a
nimal propagating and
raising.
33. The heater should be plugged in a socket, which is easily
visible and reachable.
34. Do not use this heater in the immediate surroundings of a bath,
a shower or a swimming pool.
35. Do not use this heater with a programmer, timer, separate
remote-control system or any other device that switches the
heater on automatically, since a fire risk exist if the heater is
covered or positioned incorrectly.
36.
Place the heater outside or in a large open area and well away
from any obstructions such as branches or where the heater is
close to any objects that can be affected by heat, such as
furniture, curtains or other inflammable objects (minimum
distance 1 meter).
37. The instruction manual shall provide adequate instructions for
connection to the supply ensuring an equivalent protection!
38. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Operation
Connect the power cable to a 13 amp supply which is located in a safe,
dry area.
The switch on the heater is used to control the Heater. When the
position mean on the
【
ON
】
, the first indicator light will be turn
red, the heater will be in standby mode. The
【
OFF
】
position will
turn off the Heater.
The panel control:
Although the patio heater is waterproof, do not use when raining
or in wet conditions.
Never connect the power cable from the electrical supply, when
the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the
ON/OFF
fig. 1
fig. 2
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
4
Remote control
1
5
W
ire cable
2
Installation
Heater ZHQ
1592
-C
W
-RMis built with the best quality components in
accordance to the prevailing legal regulations and certified for safety
in use. For best results from the appliance please ensure that the
installation is done by a qualified electrician in accordance with the
following instructions and taking full account of current regulations.
When using the heater, please carefully follow the instructions and
recommendations below.
You could loosen the two M
6*
10 screws to change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
M6X10
WARNING:
This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Accessories
Ref. Name
Qty
1
Explosive bolt M6*50
4
2
M6 spanner
1
3
‘
L
’
hexagonal wrench
1
4
Remote Control
1
Installation
This Heater is built with the best quality components in accordance to
the prevailing legal regulations and certified for safety in use. For best
results from the appliance please ensure that the installation is done
by a qualified electrician in accordance with the following instructions
and taking full account of current regulations. When using the heater,
please carefully follow the instructions and recommendations below.
You could
loosen the two M6*10 screws to
change the best Angle
of heating. Then retighten them.
Installation to Wall
When fixing the heater to a wall, ensure hinges are in the
underside so that the lid hands down in the open position.
Minimum required distances:
a)
500mm from the side wall
b)
500mm from the ceiling
c)
Installation height above 1.8M
flammable dust.
28.
The heater is at high temperature when in use. Unplug the
heater and wait until it cools down before cleaning.
29.
Don’t use this heater in place where causticity or volatile air
exists, such as dust, steam, gas, etc.
30.
Don’t use this heater as a cloth drier or towel drier.
31.
Don’t use this heater as a sauna heater.
32.
Don’t use this heater in place of a
nimal propagating and
raising.
33. The heater should be plugged in a socket, which is easily
visible and reachable.
34. Do not use this heater in the immediate surroundings of a bath,
a shower or a swimming pool.
35. Do not use this heater with a programmer, timer, separate
remote-control system or any other device that switches the
heater on automatically, since a fire risk exist if the heater is
covered or positioned incorrectly.
36.
Place the heater outside or in a large open area and well away
from any obstructions such as branches or where the heater is
close to any objects that can be affected by heat, such as
furniture, curtains or other inflammable objects (minimum
distance 1 meter).
37. The instruction manual shall provide adequate instructions for
connection to the supply ensuring an equivalent protection!
38. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Operation
Connect the power cable to a 13 amp supply which is located in a safe,
dry area.
The switch on the heater is used to control the Heater. When the
position mean on the
【
ON
】
, the first indicator light will be turn
red, the heater will be in standby mode. The
【
OFF
】
position will
turn off the Heater.
The panel control:
Although the patio heater is waterproof, do not use when raining
or in wet conditions.
Never connect the power cable from the electrical supply, when
the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the
ON/OFF
MODTAGER
fig. 3
Operation
Connect the power cable to a 13 amp supply which is located in a safe,
dry area.
The switch on the heater is used to control the Heater. When the
position mean on the
【
ON
】
, the first indicator light will be turn red,
the heater will be in standby mode. The
【
OFF
】
position will turn
off the Heater.
The panel control:
The Remote Control
To operate the heater, please press the remote control button.
Press one time for 20
00W, press
second time for off.
Although the patio heater is waterproof, do not use when raining
or in wet conditions.
Never connect the power cable from the electrical supply, when
the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the
surface of the patio heater with a damp cloth. Never use
corrosive or solvent cleaners or immerse in water.
•
Any maintenance or repairs including replacing the halogen
tube should only be carried out by a qualified electrician or by a
recommended service center.
Technical specification
•
Power supply 220V-240V~50Hz
•
Wattage 2000W,
•
Net weight 1.9kg
•
Insulation class I
•
Dim: 59.5x10cm
ON/OFF
fig. 4
