background image

GB

          

Instructions

Read the instructions before use

Keep the manual for any questions of future use of your product. The product is designed and 

manufactured in compliance with European standards: CE, RoHS.

General safety instructions

• Use the heater only on flat and stable ground.

• Do not cover the product or the heater’s grill.

• Do not use under a table with a tablecloth that extends more than 4 cm of the table egde.

• Do not use a blanket while using the heater, as this may block the heater.

• Do not place bags, rugs or other objects in such a way that they block the grill.

• Do not use the heater close to curtains and other combustible materials.

• Required space between bottom of the table and the top of the heater is 5 cm.

• Do not insert foreign objects into the heat source behind the grill. 

• Connect the product only to outlets with earth. 

• Do not place the heater directly below a socket outlet.

• Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pool.

• Always take the product indoors after use, and let the product cool off before packing it away

• Do not use this heater outdoor during bad weather like rain, storm or snow.

• Do not use this heater with a programmer, timer or any other device that switches the

  heater on automatically, since a fire risk exists if the heater is covered or positioned

  incorrectly.

Maintenance and cleaning

• Disconnect the plug from the socket before cleaning or when the product is not in use for

  prolonged periods of time.

• Do not clean the product until 60 minutes after it is turned off.

• When cleaning, do not spray cleaners or water directly into the product.

• Apply the cleaner on a cloth and wipe the product.

• Regularly check the cord for damages and ensure that the plug is clean.

• If the power cord, lamp or other electrical parts needs replacing, this must be done only by a professional 

 

  electrician.

Troubleshooting

Follow the troubleshooting steps listed below:

• Make sure the power cord is connected correctly.

• Check the cable for any ruptures.

• Make sure the ON/OFF switch has been switched OFF.

• Check whether the bulb has blown.

• If the product is turned off due to overheating caused by improper use (overheat sensor), the product 

 

  must be disconnected from the socket outlet and cool off. Check the product for defects after 30 minutes  

  of cooling. If there are no visible defects, try to reconnect the product again. Please contact the place of    

  purchase if this did not solve your problem.

Disposal

European directive 2002/96/EC on Electrical and Electronic Equipment Waste (WEEE), requires 

that old household appliances are not thrown into the normal municipal waste stream. The 

appliances should be collected separately to maximize the recovery and recycling of materials 

and reduce the impact on human health and the environment. The symbol of the “crossed off 

dustbin” is stamped on the product to recall the obligations of the separate collection. Consum-

ers should contact their dealer or local authorities regarding the procedure to be followed for the 

removal of their product.

4

Summary of Contents for 211-357














Reviews: