48
START-UP STAGE
The stove start-up phases are carried out in sequence, following the set time parameters.
FAILED SWITCHING ON
After Pr01 time, if the fume temperature hasn't reached 50°C, the alarm goes off.
OPERATING STOVE
After having been successfully switched on, the stove shifts to normal working phase. If the fume temperature is higher than
Pr15, heat exchangers are automatically activated.
ROOM TEMPERATURE SETTING
To change the room temperature, simply select the MODIFY SET ENVIRONMENT mode by pressing the P2 key. Then press the P1 and P2 keys
to set the desired temperature. After a few seconds from the setting the display will return to display the operating information.
USE OF THERMOSTAT/EXTERNAL CHRONO-THERMOSTAT
You can use an external thermostat. We strongly suggest that you contact a qualified technician for installation.
Thermostat: program a temperature SET of 7°C
External chrono-thermostat: program a temperature SET of 7°C and disable the chrono functions in the menu.
WHEN THE ROOM TEMPERATURE HAS REACHED THE SET VALUE
When the room temperature has reached the set value, or the fume temperature gets to Pr13, the heat power is automatically
brought down to minimum value, called MODULATION. If the STAND-BY mode is activated, the stove starts to working again until
Pr13 value is reached. Restart is possible when the above conditions are fulfilled.
RESTART AFTER SWITCHING OFF WHEN TEMPERATURE REACHES SET ROOM TEMPERATURE
After the switching off has been completed, the stove is in a cooling condition, the fume exhaustion smoke is brought to maximun level
into the final cleaning phase. Restart is possible as soon as the room temperature falls below the set determineted.
CLEANING THE BRAZIER
During normal working condition, at intervals programmed in the operating parameters, the CLEANING BRAZIER mode is activated for a
period of time predetermined. In this phase it will be noticed an increase in the rotation of the fumes aspirator and a decrease in the
descent of pellets, this to allow complete combustion and the lifting and extraction of the ashes inside the brazier.
SWITCHING OFF THE STOVE
To switch off the stove, simply press the P4 button for about 2 seconds. The auger is immediately stopped and the fume exhaustion is
brought to a high speed working mode. The FINAL CLEANING phase is carried out. The operation of the smoke extractor is disabled, after
the set time has elapsed after the smoke temperature has fallen below the value of the reference parameter, the stove switchs off.
SWITCHING ON THE STOVE AGAIN
The stove can not be restarted until the fume temperature has dropped below the parameterized value, and the safety time has not
elapsed.
Summary of Contents for DOMUS
