GOOD TEST:
top jack
GOOD TEST for PIN 2 HOT
GOOD TEST for PIN 3 HOT
GOOD TEST for PIN 2 HOT
GOOD TEST for PIN 2 HOT
GOOD TEST for PIN 3 HOT
GOOD TEST for PIN 3 HOT
XLR (M) to TS 1/4” (UNBALANCED)
TS 1/4” (UNBALANCED) TO XLR (F)
XLR (M) to RCA (UNBALANCED)
In a properly wired unbalanced cable such as this one, Pin 1 and Pin 3 of the XLR (representing Shield and Cold,
respectively) are bridged. The red LEDs under “C” (Cold) and “S” (Shield) will illuminate to show this condition.
In a properly wired unbalanced cable such as this one, Pin 1 and Pin 3 of the XLR (representing Shield and Cold,
respectively) are bridged. The red LEDs under “C” (Cold) and “S” (Shield) will illuminate to show this condition.
In this tester, the RCA jacks are referenced to the H (Hot) and S (Shield) LEDs. In a properly wired, Pin 2 Hot unbal-
anced cable such as this one, Pin 1 and Pin 3 of the XLR (representing Shield and Cold, respectively) are bridged.
The red LED under “S” (Shield) illuminates to show this condition. Since the LEDs are referenced to the jacks on
the right, and since the RCA jack has only two contacts (Hot and Shield) the red C (Cold) LED does not illuminate.
top jack
Exception: Use the top
1/4” Jack for this test.
Exception: Use the top
1/4” Jack for this test.
