4
Encoder
Pan-Tilt
NO
Use encoder correct position
OFF
Do not use encoder correct position
No DMX
Signal
KEEP
According to the original state continues to run
CLEAR
The return of the motor, stop running
Display
Power Save
NO
Free 30 seconds after closing backlight
OFF
Backlight ever bright
Burn on
start up
OFF
Power on directly after reset, no light bulb (need to use the menu or control table
to manual light bubble)
NO
After power on automatic light bubble, must wait for the light bulb light up
success can be reset
Load
Default
Press ok key see the confirmation dialog box, again press ok key, Press OK key
into edit
2.3. Information interface
Option
Instruction
Total using time
Cumulative using time (Accuracy to the minute)
The use of time
Use of time since the boot (Accuracy to the minute)
System error logs
If the red indicator shine ,that mean the lamps runs error . The details can be entered
sub-interface to view
After you finish view,
you can press the "OK" key to make the error log empty. Pay attention: Sometimes not
the Hall or optical coupler installation problems, But the motor cable is connected
backwards
2.4. Manual control interface
This interface use to control present light, neither belong to the from the mac
hine state (didn’t received DMX signal),
nor belong to Host state( send DMX signal).
Option
Instruction
Reset
Press ok key see the confirmation dialog box, again press ok key, enter the reset interface, all
motor reset.
Color wheel
0-255
Press OK key into edit state, its selected hundred. Press up or down,change
channel value .Press again OK key, selected ten editor. Press again OK key,
select the edit. Press it again to exit the edit state.
……
0-255
the speed of
gobo wheel
0-255
Blub control
ON
OFF
2.5 Advanced interface
Password is “Up down up down “ . For the runner , password is “Left right left right”
Touch operation : Press one time on the “up” key (Appear the first “*” ),Then press one time on the “down” key
(Appear the second “*” ) , Press one time on the “up” key again (Appear the third “*” ) , Press one time on the “down”
key again (Appear the fourth “*” ) . At last press “OK” key to do the password authentication .
Runner operatio
n : Turn to the left 1 bar (Appear the first “*” ), then turn to the right 1 bar (Appear the second “*” ),
