Hosen MH LED 60D, User Manual

              Gobo 
Replacement 

LED

Replacement

1) Unlock the gobo cover and slide it away. 
2) Take the target gobo out of the gobo wheel. 
3) Install the new rotating gobo. 
4) Slide and lock the gobo cover. 

Make sure to disconnect the fixture's power cord before replacing the gobo. 

1) Remove the head cover by loosening its screws. 
2) Remove the fan cover, the head fan, the fan support and the heat sink in this order. 
3) Disconnect and remove the LED. 
Mount and connect the new LED. 
5) Reverse steps "2" and "1". 

Make sure to disconnect the fixture's power cord before replacing the LED.

DMX Linking

DMX Modes

Master/Slave 

Linking

You may link the light to a DMX controller using a standard DMX serial connection. If using 
other DMX compatible fixtures with the light, it is possible to control them individually with a 
single DMX controller. 

It is also possible to run several DMX compatible fixtures synchronized without a DMX 
controller in a master/slave operating mode. 

If you are not familiar with the DMX standard, please refer to the DMX Primer and
DMX Connectivity sections in the Appendix chapter of this manual. 

The light uses the standard DMX data connection for its DMX modes, Advanced and 
Basic. Refer to the Operation Instructions chapter to learn how to configure the light 
to work in these modes. The DMX Values section will give you detailed information 
regarding the above-mentioned DMX modes. 

The Master/Slave mode allows a fixture (the master) running a  preconfigured 
program to control several other fixtures (the slaves) without requiring a DMX 
controller. In this mode, all the slave fixtures will operate in 
unison with the master fixture. 

When in Master/Slave mode, the units link to each other using the standard DMX 
connection. 

If you are not familiar with the Master/Slave connectivity, please refer to the DMX
Primer and DMX Connectivity sections in the Appendix chapter of this manual. 

The Operation chapter of this manual provides detailed instructions on how to 
configure the Master and Slave units. 

--6--