2
2A9584-010
Fig. 2
Preparing Existing Lower Icemaker
2) Remove the front panel and move the control switch to the "OFF" position and turn off the power supply. Place the
icemaker disconnect (if applicable) in the off position. Lockout/Tagout to prevent the power supply from being turned
back on inadvertently.
WARNING! Control switch in "OFF" position does not de-energize all loads.
3) Empty the ice storage bin of all ice.
4) Remove the top, left, and right panels. See "II.C. How to Remove Panels" in the instruction manual. Also remove the
lower rear panel. See Fig. 1.
5) Remove the top frame front gasket from the lower icemaker. See Fig. 1. Next, place the top panel hook provided in this
kit, on top of the frame, then place the gasket provided in this kit, on top of the top panel hook.
Top Frame
Front Gasket
Connector Guide A
Top Panel Hook
Fig. 1
Wire Channel
7) Connect the wire harness provided in this kit, to bin control connector B and control board connector A.
See Fig. 3.
Fig. 3
Bin Control Assembly
Connector B
Connector A
Control Board
Bin Control
Wire Harness
Control Board
To Upper Icemaker
Connector B
Connector A
Connector A
Connector B
6) Remove connector guide A, then disconnect the bin control connector located in the wire channel. See Fig. 2.
Lower Rear
Panel
