D. Setup
NOTICE
• Do not place more than 33 lb. (15 kg) on the top panel.
• Do not use the frame to lift the appliance. Lift the appliance from the base.
• Handle the appliance carefully to avoid damaging the exterior.
1) Unpack the appliance, and remove all shipping cartons, tape, and packing material
BEFORE operating the unit.
2) Position the appliance in its permanent location.
3) Level the appliance in both the left-to-right and
the front-to-rear directions (when installed with or
without legs). See Fig. 2.
4) If mounting flat to a counter, seal the perimeter
where the appliance contacts the counter with
approved caulk compound in a smooth and easily
cleanable manner.
5) If installing the unit with legs on the bottom, use the
four accessory legs adjustable from 6" (15.2 cm) to
7" (17.8 cm). Screw the legs tightly into the tapped
holes in the base. See Fig. 3.
Max. 0.2" (5mm)
[0.3°]
Fig. 2
Tapped Hole
(Leg Mounting)
Base
Adjustable Leg
Fig. 3
12
