34
*
To check the current memorized model code, view in the display mode (press and
hold
the service 1 switch for 3 seconds – the display changes to “n1”, then press the
service 1 switch several times to find "h6", then press the reset switch and the
memorized code appears in the display).
*
If for any reason the machine needs to be reset back to the factory settings, hold the
service 1 and service 2 switches for 15 seconds whilst the code is displayed (in
display mode). The machine
will stop working and the display will reset to “00” (cleared
memory).
The controller board will then need to be reprogrammed (select and memorize the
correct code for the machine) using steps 7) and 8) above.
Note:
1. Be sure to get static free before servicing the controller board.
2. Do not touch the controller board with wet or dirty hands.
3. Do not impact the controller board. If it drops on the floor, do not use it.
4. Do not hold the leads when disconnecting the connectors.
* Locking connectors must be unlocked before being disconnected.
* Reconnect the connectors properly.
5. Install the new controller board in its correct position.
6. Bind the wiring inside the control box the way it was.
* Do not push the wiring on the controller board.
* Do not bind the thermistor leads and high voltage wires together.
