38
III. OPERATING INSTRUCTIONS
1. IN CASE OF DIRTY WATER
1) Remove the switch cover and turn off the power
switch.
2) Close the water supply tap.
3)
Unscrew and lift off the front panel. See Fig. 1.
4) Wait for 5 minutes and turn on the power switch.
5) Forty seconds after the icemaking compartment starts
operation, turn off the power switch immediately to drain
the water tank. Note the open position of the water tank.
6)
Refit the front panel, and screw in place
. See Fig. 1.
7) When water supply is resumed, open the drain valve first.
Then, gradually open the water supply tap to completely
drain out dirty water.
7) Turn on the power switch to restart the ice dispenser.
Reattach switch cover.
2. PREPARING THE ICE DISPENSER FOR LONG STORAGE
1) Press the push button to dispense all ice from the storage bin.
2) Follow the steps 1) to 5) in “1. IN CASE OF DIRTY WATER”.
3) Blow out the water supply line immediately after the water pan has opened.
Note: This procedure is necessary to protect the ice dispenser from freezing up at
subfreezing temperature.
4) Unplug the ice dispenser or disconnect the power source when the water pan has
fully opened.
5) Clean the storage bin liner, spout, drain pan and ice station, and dry them thoroughly.
See “IV. MAINTENANCE INSTRUCTIONS”.
6)
Refit the front panel
and screw in place.
Fig. 1
