61
9. PUMP MOTOR
1) Unplug the ice dispenser or disconnect the power source.
2)
Remove the top panel and front panel.
3) Disconnect the pump motor leads in the wiring channel.
4) Remove screws and the pump motor from the bracket.
5) Disconnect the pump suction and discharge tubing.
6) Disassemble the pump motor and check the motor or parts.
7) Install the new motor or parts in the reverse order of the removal procedure.
8) Plug in the ice dispenser or connect the power source, and check for leaks.
9) Replace the panels in their correct positions.
10. WATER VALVE
1) Close the water supply tap.
2) Unplug the ice dispenser or disconnect the power source.
3)
Remove the top panel and front panel.
4) Disconnect the receptacle (leads) from the water valve.
5) Remove the valve outlet tubing by releasing the clamp.
6) Remove the inlet hose and water valve.
7) Install the new valve in the reverse order of the removal procedure.
8) Open the water supply tap.
9) Plug in the ice dispenser or connect the power source.
10) Check for leaks.
11) Replace the top panel in its correct position.
Note: When replacing parts, disassemble as shown in Fig. 7 and replace the defective
parts.
